"No" choice for that pop-up, there's only an "OK" choice. If you installed Wireshark using the package from, Try re-installing it and checking the box for the "Set capture permissions on startup" item. Please check to make sure that you have sufficient permissions. The capture session could not be initiated on interface 'XXX' (You don't have permission to capture on that device). If you haven't installed ChmodBPF, and you try to start a capture, you will get a pop-up that says "install ChmodBPF to fix this" is in blue and is underlined this indicates that you can click on it and, if you do, it will start up the ChmodBPF installer run the installer, by clicking "Continue" and continuing through the process. If, however, you haven't installed the "ChmodBPF' component in the image, if you start up Wireshark 3.2.7, there will be, on the main Wireshark screen, above the list of network devices, a message "You don't have permission to capture. The Wireshark 3.2.x disk image is a drag-install image, so you won't get the pop-up at installation time. I clicked "NO" and I think this is my problem. I had to update wireshark, and if I remember correctly, a pop up asked me about root permission or something.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |